I am going to rebuild my engine this fall and was wondering about a couple
of rules, if anyone cares to help me out. I have 10900 on my Eagle Talon
and it burns a little oil and is down on compression a bit. Here is what I
want to do, can I
A lightned flywheel, which is OK I think
Balance the crank shaft
New valves seals OEM
Rings, bearing and new gaskets OEM
and here is the real question
a 3 angle valve job????
If I can't do the valves and I don't want to mill the head at all, what can
be done?
Dan
________________________________________________________________________
|