buick-rover-v8
[Top] [All Lists]

Fw: Jeep axles

To: <buick-rover-v8@autox.team.net>, <mgb-v8@autox.team.net>
Subject: Fw: Jeep axles
From: "HoYo" <hoyo@bellsouth.net>
Date: Fri, 17 Oct 2003 09:47:23 -0500
>   thanks! for the info, and SORRY! the damn rear axle is one of those
funky
> round cover AMC model 20's...pretty useless i guess except for a 'Jeeper'
> guy as my kids would say....may just use a Ford 9 inch in a '78 Ford van i
> have.....i think the front axle may be a model 30 Dana w/steering
> linkage/kingpins/etc.   HoYo
> ----- Original Message -----
> From: "Greg Myer" <motorhead45@juno.com>
> To: <hoyo@bellsouth.net>
> Sent: Wednesday, October 15, 2003 1:27 PM
> Subject: Re: Jeep axles
>
>
> > HoYo
> >            The Dana 44 I took out of a Postal Jeep had 2 tags on the
> > cover.
> > One had the gear ratio and the other had the Posi  I.D.
> > I don't know about the 4 wheel drive versions.
> > I am interested in knowing how log the short side axel is.
> > I'm thinking of narrowing the housing and using 2 of them to fit
> > wider wheels. ( I know , move the springs inboard and tub it .....
> > lots of work for wider wheels ) But if you're pulling it apart anyway,
> > I'd like to know. If it'll work, I'll be looking for two of them.
> >                                                Thanks,   Greg
> >
> > On Wed, 15 Oct 2003 13:24:37 -0500 "HoYo" <hoyo@bellsouth.net> writes:
> > > Hi gang,
> > >  i just received 2 free axles from i believe a CJ5,6,or 7. the front
> > > i can't
> > > use nat. and the rear is too offset to use . they weren't from a
> > > mail
> > > truck(CJ6?) but i was wondering if both have posi chucks? they
> > > should be a
> > > Jeeps are 4WD and was thinking of keeping the chunks to use in
> > > another(mailtruck) axle when i get one.can some one give me a primer
> > > on where
> > > the#'s are and what they mean? like where's the axle ratio #'s ,etc.
> > > thanks!
> > >                                                        HoYo

///
///  buick-rover-v8@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>