I recently fitted all new rigid lines to my SP310 so beware it is a RHD
model.
However the rear lines are: -
Rear Right - 490mm
Rear Left - 810mm
Those measurements are ~ 20mm longer than the original to allow for
flare stuff ups, so I advise not to exceed them too much or you'll have
a lot of length to lose somewhere!
Best measure your existing to be sure, to be sure!
I used string to follow the curves and then measured that with a tape.
Regards,
Graeme S.
nissanman.shutterfly.com
On 1/10/2013 9:28 AM, Ronnie Day wrote:
> I FINALLY managed to get the flare nut lose on the driver's side wheel
> cylinder on my '70 2K, but the nut is ruined so I need to replace the line.
> Does anyone know the length of that line? It's the longer of the two on the
> rear axle. I'm hoping to find an off the shelf piece that I can bend to
> fit. I've got a small tubing bender and have bent tubing before. I'd prefer
> not to roll my own from scratch.
>
> Ron
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/graemes@internode.on.net
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|