Figure Eight Gaskets

[N197TR4@cs.com]

Help!

OK, I wasnt paying attention when we had earlier threads on this.

But engine #1 seemed to be perfect in everyway. Engine #2 is just going to 
require a little more fiddling.

I am going to bite the bullet and raise the liners up where they should be. I 
am so close, timewise, to removal of liners anyway. I want to be able to put 
my GasketWorks copper gasket back where it belongs. 

Mordy, have you made figure eights of various thickness? Jack, what have you 
done? Anyone else?

Joe