In a message dated 4/9/03 2:36:06 PM Pacific Daylight Time,
vinttr4@geneseo.net writes:
<< Believe me, the part is like a piece of jewelry, and if for some reason
you
would like a light flywheel but would rather not run an aluminum one, this
part is for you.
>>
Is this flywheel the same as the Tilton aluminum flywheel? In other words,
will the Tilton Clutch bolt to it, or do you have to use the stock pressure
plate? I believe that Tilton once offered the choice of an aluminum flywheel
and an identical steel flywheel which was just slightly heavier. They were
both drilled for the smaller diameter Tilton pressure plate and for the stock
pressure plate.
|