fot
[Top] [All Lists]

RE: Slicone gaskets--Atten: J Wagner

To: Bill Babcock <BillB@bnj.com>,
Subject: RE: Slicone gaskets--Atten: J Wagner
From: Bill Babcock <BillB@bnj.com>
Date: Wed, 18 May 2005 16:07:04 -0700
 I don't seem to have all the bits either--I'm one bolt and lot of the
washers short. I'm using the standard (not aluminum) pan. Can I get a set of
washers from you quickly?

Bill Babcock
2345 NW Amberbrook Dr
Beaverton, OR 97006

If you have them, send them fedex and I'll pay the shipping. 

Bill

-----Original Message-----
From: owner-fot@autox.team.net
To: ''FOT' '
Sent: 5/18/2005 3:56 PM
Subject: Slicone gaskets--Atten: J Wagner

I've pretty much found my oil leak, the sump gasket was soaked with oil
at
the front of the pan. It's NOT a silicone one--I decided I needed the
ground
clearance under the pan. 

Back to silicone. 

I have a silicone gasket, and I have the safety wire instructions, but I
don't have the gasket instructions. Justin, can you tell me what to
torque
the pan to. 

<Prev in Thread] Current Thread [Next in Thread>