Russ Moore wrote:
> Stahl is the only way to go!
> Anything else is a waste of money. The stock Mk2 is not bad for an 1147, but
> you'll never regret the Stahl once you put it on. You will need to cut out a
> portion of the belhousing and the rear engine plate, but it's worth it. You
> will notice the difference.
>
> Russ Moore
>
> ----- Original Message -----
> From: "Norlin Engineering" <norlinengineering@comcast.net>
> To: <fot@autox.team.net>
> Sent: Tuesday, June 26, 2007 1:55 PM
> Subject: [Fot] Spitfire Headers
>
>
>
>> Does anyone know of a ready source for Spitfire headers that will stay
>> tucked up in the frame? This is for a 1300 and the engine builder says I
>> should stick with a tri wye design for the prep level of the motor he's
>> building. The headers available from the sources I've found so far are
>> apparently for street cars since they hang 1 1/2 to 2 inches below the
>> frame.
>>
>> Thanks
>>
>> Jim Norlin
>> _______________________________________________
>> http://www.team.net/donate.html
>>
>> rem9@frontiernet.net
>> Fot mailing list
>> Fot@autox.team.net
>> http://autox.team.net/mailman/listinfo/fot
>>
> _______________________________________________
> http://www.team.net/donate.html
>
> gaf3@charter.net
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
>
I also have a set of Stall headers and I have an interference with the
dipstick tube as well.
Glenn
72 spit racer under construction
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|