Oh...and....Since you are an 'Unwashed Mechanic'...You're already on top of
the world...Work on that Tr so late that you're too tired to think about a
shower...Don't worry about the grease on the pillow from the oil puddle that
your head rested in!..Funny..but true...
RB
----- Original Message -----
From: "Robert Blake" <rblake36@yahoo.com>
To: "FOT" <fot@autox.team.net>
Sent: Sunday, August 16, 2009 7:12 PM
Subject: [Fot] Rod bearings
> Unwashed shade tree mechanic in need of advise. Am attempting to replace
> the
> rod bearings on my TR4 with minimal success. After loosening the nuts I
> attempted to push the piston up off the crank using the wooden handle of a
> mallet placed against the meaty part of the piston where the wrist pin
> sets.
> No movement. Yes, I actually did pull the plugs first! I was reluctant to
> beat it too hard. Checked the archives for previous posts on this issue
> but
> found none. Appreciate any suggestions.
>
> Bob Blake
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|