fot
[Top] [All Lists]

Re: [Fot] AN hardware and halfshafts

To: "'Scott Janzen'" <s.janzen@comcast.net>, "''Friends of Triumph'
Subject: Re: [Fot] AN hardware and halfshafts
From: "Joe Curry" <spitlist@cox.net>
Date: Sat, 17 Oct 2009 08:56:36 -0700
Most likely, it is the Nyloc nuts.  I would say use a bit of Loc-Tite on the
threads and see if they still work loose.

Joe C.

-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Scott Janzen
Sent: Saturday, October 17, 2009 8:42 AM
To: 'Friends of Triumph' Triumph
Subject: [Fot] AN hardware and halfshafts

My GT 6, with a welded diff, has the halfshaft u-joints bolted to it  
with AN6 hardware.  I was checking out various things under the car  
two events ago and noticed that all of the bolts/nyloc nuts were about  
1/8-1/4 turn loose.  I tightened them up, but after the next event  
they were about one flat loose again.  There's no way to get a torque  
wrench at these, given the proximity to the diff and the u joint on  
the other end of the bolts, so I just give them a good yank with hand  
wrenches.

Question - are these stretching, working loose (with nyloc), or are  
the AN washers, which I find to be fairly soft, compressing?  I really  
lean on the wrenches, so I am amazed the nuts are loosening.  I know  
the welded diff puts a lot of stress on the system, but none of the  
hardware on the outer u joints or the drive shaft, all of which have  
smaller hardware, is loosening, and the events I'm talking about are  
only hillclimbs - not a lot of driving time at all.
You are subscribed as spitlist@cox.net

Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

_______________________________________________

Support Team.Net http://www.team.net/donate.html

http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>