fot
[Top] [All Lists]

Re: [Fot] Engine Plug Sizes, oil press pickup

To: steve <colordog.1@earthlink.net>
Subject: Re: [Fot] Engine Plug Sizes, oil press pickup
From: "J.C. Hassall" <jhassall@blacksburg.net>
Date: Wed, 23 Dec 2009 16:53:42 -0500
On 12/22/2009 3:17 PM, steve wrote:
> Oops, sorry about the typos.  The heater pipe hasn't screwed anything as far 
>as I know!!!
>
> I need a plug to block off the heater pipe hole atop the head. :)
>
> -----Original Message-----
>> From: steve<colordog.1@earthlink.net>
>> Sent: Dec 22, 2009 11:40 AM
>> To: FOT<fot@autox.team.net>
>> Subject: [Fot] Engine Plug Sizes, oil press pickup
>>
>> FOT,
>>
>> What sizes are the following plugs for the TR3/4 engine:
>>
>> 1, top of Cyl Head where heater pipe screwed it.
1/2" NPT
>> 2,  Manifold side of engine block to drain H2o.
1/2" fine thread


-- 
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________

Support Team.Net http://www.team.net/donate.html


http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.

<Prev in Thread] Current Thread [Next in Thread>