fot
[Top] [All Lists]

Re: [Fot] TR4 Main Bearing Clearance

To: timmurph@fastbytes.com
Subject: Re: [Fot] TR4 Main Bearing Clearance
From: "Joe Boruch" <jaboruch@netzero.net>
Date: Wed, 20 Jan 2010 01:58:45 GMT
Tim, I been having my blocks align honed and then we double check all the
clearances.  Any block that I have used has needed some align honing.  I run
0.0025 inch clearance.  Were each of the bearing halves measured in multiple
places?  I usually take 9 measurements on each with a caliper with ball tips.
Measure 3 spots across near each end and 3 spots across the center.  You could
have had a bearing half that was thicker in some spots.  Also, 0.002 is way
too close for these engines, never mind 0.001.

I would also suggest an oil accumulator, since even with the big pan you could
have some oil starvation.  I would also suggest a synthetic race oil, after
you break it in with a mineral based oil.
I have not tried the coatings, but would also be interested in other's
experience.
That's my 2 cents.  Joe(B)

---------- Original Message ----------
From: "Tim Murphy" <timmurph@fastbytes.com>
To: <fot@autox.team.net>
Subject: [Fot] TR4 Main Bearing Clearance
Date: Tue, 19 Jan 2010 18:23:11 -0600


____________________________________________________________
Diet Help
Cheap Diet Help Tips. Click here.
http://thirdpartyoffers.netzero.net/TGL2231/c?cp=3EeCJrN5Qv3oedh4Vg9_vwAAJz6U
0HcZ7PRpF0fndYeeSkVqAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAYQAAAAAA=
_______________________________________________

Support Team.Net http://www.team.net/donate.html

Suggested annual donation $12.96


http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.

<Prev in Thread] Current Thread [Next in Thread>