Max
On my race TR6 I do not run the dust covers as they go to toast first race .
never had a problem with leaks but i always clean pistons with brake clean
and air before pushing back to insert new pads . i have found varying
quality in the seals and am very particular which seals i use.
Can you give more details of the rings eg material and likely cost
Geoff Byrne
TR6 Racer Down Under
----- Original Message -----
From: "MadMarx" <tr4racing@googlemail.com>
To: <fot@autox.team.net>
Sent: Friday, October 15, 2010 6:19 AM
Subject: [Fot] Brake caliper sealing rings
> Hi FOT,
>
> after I got bothered over years by leaking brake seals I started to
> develop
> rings out of special DOT 3;4;5.1 resistant rubber with extended heat
> resistance.
>
> They are made for racing purpose and surprisingly they also do help
> against
> pad pushback.
> I have run the sealing rings the whole season and had no leaks and hard as
> a
> rock brake pedal.
> As the dust cover do get toasted during racing I replaced the dust cover
> by
> a slotted ring to prevent the enter of dirt into the caliper.
>
> These rings are expensive because of the material they are made from.
>
> I didn't order a run of rings as I have to take the minimum of 240 from
> the
> manufacturer to get an acceptable price.
>
> If there is interest on your side I would like to know.
>
>
> Cheers
> Chris
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/fot/gkbyrne@optushome.com.au
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|