Good point about drilling the extra holes. I have not taken the time to do
so.
I have not added the holes in the reman scroll seals that I have distributed,
either.
As a reminder, there is a modification that needs to be done on the seal
housing to clear the holes.
Another reminder: it is necessary to check the length of the flywheel
attachment bolts to insure they are not too, long. There has been two seals
destroyed because of this. This check should be done, in any case, of course.
Joe Alexander
A. R. E.
645 1st Street
Jesup, Iowa 50648
319.464.4711 (cell)
n197tr4@cs.com
-----Original Message-----
From: Bob Kramer <rkramer3@austin.rr.com>
To: fot <fot@autox.team.net>; Tony Drews <tony@tonydrews.com>
Sent: Wed, Feb 1, 2012 10:30 am
Subject: Re: [Fot] VACUUM SYSTEM
Tony,
I do that on all my engines too. My TR4A doesn't leak from the rear seal
(very much) with just a BFE kit and two hoses running from the draught tube
location and the valve cover to a catch can. As others have mentioned, just
the oily mist that comes out of that can and the minor leaks get the engine
compartment dirty after a few weekends.
On the TR4 my son drives I realize that the vacuum system is set up wrong,
sucking from the draught tube location and the engine is not sealed. I did
replace the crankshaft after a tranny case failure (PO sysdrome) but I kept
everything else as is. The rear seal is an obvious compromise but I'm going
to seal the engine and hook the evac tube to the valve cover as has been
suggested and see just how bad it is before I pull the engine.
Bob Kramer
512-815-9925
rkramer3@austin.rr.com
Perfection is not attainable, but if we chase perfection we can catch
excellence.
Vince Lombardi
----- Original Message -----
From: "Tony Drews" <tony@tonydrews.com>
To: "Bob Kramer" <rkramer3@austin.rr.com>; <fot@autox.team.net>
Sent: Wednesday, February 01, 2012 9:51 AM
Subject: Re: [Fot] VACUUM SYSTEM
> Back to your rear seal issue - one thing that was pointed out on the list
> a year or so ago that I did with my last rebuild is to drill additional
> drain holes through the rear main. I drilled them parallel to the
> existing drain tube. 3/8" diameter. Helps give the copious quantities of
> thick oil a place to go other than into the bellhousing.
>
> Tony Drews
>
> At 09:02 AM 2/1/2012, Bob Kramer wrote:
>>It looks like it might be worth trying to set up my vacuum system properly
>>and
>>see just how bad the rear seal really is. Mine sucks from the draught tube
>>location, easy access to oil and too many leaks in to the engine.
>>
>>Sent from my iPhone
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/n197tr4@cs.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|