Glenn,
This is a very common swap and will actually be a better setup as the case
of the TR6 gearbox is stronger than a TR4 box. You most likely will need
longer studs at the top of the engine because the gearbox flange is thicker.
The TR6 output flange you mention is actually a better option as it is
stronger than the TR4 flange and mates up to the driveshaft the same as the
earlier flange.
Steve Yott
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of Glenn Franco
Sent: Friday, May 10, 2013 12:06 PM
To: Friends of triumph; 6pack@autox.team.net
Subject: [Fot] Early TR6 Trans into a 64 TR4
Group
Will a 1970 TR6 4 speed trans swap into a 1964 TR4.
I'm in the process of adapting an A-type O/D to a Trans and have lots of
spare 4 speeds around and thought it would be easier to mate up the 2 (trans
and O/D) for a quick swap later.
The only big difference I have seen is the rear companion flange is
different than a TR6 but the O/D has a TR4 Flange.
Thanks in advance
Glenn
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|