fot
[Top] [All Lists]

[Healeys] TR6 question

Subject: [Healeys] TR6 question
From: tomfelts at windstream.net (Tom Felts)
Date: Sun, 1 Jan 2017 9:32:42 -0500
Which, FWIW, is about 30 miles from my house. They are well stocked with 
Triumph parts.


---- WILLIAM B LAWRENCE <YNOTINK at msn.com> wrote: 

=============
There was a time when you couldn't find a decent throw bearing for these. the 
OEM were cheap and tended to lock up, taking out the fingers on the diaphragm 
pressure plate. I think most suppliers are using a Toyota bearing in its place 
with good results.


The best parts source (and source of the best parts) for these as well as 
having an incredibly detailed catalog with practically every part ilustrated in 
blow-up is The Roadster Factory in Armagh, PA.


Bill Lawrence

BN1 #554

________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of Frank Magnusson 
<fmags at cox.net>
Sent: Saturday, December 31, 2016 7:27:38 PM
To: healeys at autox.team.net
Subject: Re: [Healeys] TR6 question

Things to look for:

A. Rocker panel rot just in front of the doors.  The scuttle vent has a water 
drain tube on each side that just exits between the body and the fender at this 
spot and if any leaves, etc get down in there, this is where it rots out.  
Check it with a magnet for bondo.

B. Rot on the valence panel where the top attaches to the body at the rear, on 
the sides where it meets the rear fender.  Not sure why it rots here, but its 
notorious.

C.  Cracks on the front shock towers.  Easily welded to repair.

D. Diff mount cracks.  The rear springs are fairly soft and put a lot of load 
into the diff mounts when you accelerate.  One of the four is worst; dont 
recall which.  Easily welded.  If you get the car, upgrade the springs to 
competition springs which are much stiffer and upgrade the shocks with heavier 
duty valving.  Lots of people chnage over to telescoping shocks and there are 
kits to do that, but I never had a problem with the originals.

E. juddering clutch.  Really only a factor on higher mileage cars due to 
Triumphs clutch release mechanism design.  Stag has it much worse due to the 
bigger engine and gearbox but starting to show up on other models.  Buckeye 
Triumphs in Ohio has a great article on how to fix it, whihc worked on my Stag.

Other than that all the usual stuff, rust, bondo, synchros.  Engine is fairly 
bullet proof.

This is one of the better Triumphs.  Its no big Healey, but its a great car and 
much more roadable than the other Triumphs due to the 15 inch wheels.  Great 
car.  OD is a plus, but very easy to install one if you can find one.  They're 
around.

Hope this helps,
Frank


_______________________________________________
Archive: http://www.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys




<Prev in Thread] Current Thread [Next in Thread>