fot
[Top] [All Lists]

[Healeys] Stripped Water Pump Stud

Subject: [Healeys] Stripped Water Pump Stud
From: bspidell at comcast.net (Bob Spidell)
Date: Sat, 27 May 2017 06:09:17 -0700
References: <20170527074042.LFRMD.11774.root@pamxwww06-z01>
Agreed, but be careful; with enough leverage you could snap it off.  I'd 
soak it in your favorite penetrating oil--I like Kroil--for a few days.  
Maybe heat the area with a propane torch to help the oil penetrate.

Bob


On 5/27/2017 4:40 AM, Tom Felts wrote:
> get new and larger vice grips--seriously.
>
> tom
> ---- Patrick & Caroline Quinn <p_cquinn at tpg.com.au> wrote:
>
> =============
> G'day
>
>   
>
> Had a half hour to spare this afternoon so I thought I would fit the new
> water pump to the BN3's six-cylinder engine.
>
>   
>
> Of the four nuts, three tightened without a problem. but I managed to strip
> the thread the stud thread on the fourth.
>
>   
>
> Normally I would use the twin nut method, but with the stud stripped that's
> not possible. So what to do? My 40+ year old vice-grips (mole-grips) can't
> handle the strain and I don't have a welder to weld on a nut, nor do I have
> an extractor.
>
>   
>
> Was thinking about filing the end of the stud flat on two sides and using a
> crescent wrench or what we call a shifting spanner. Any experienced advice
> out there?
>
>   
>
> Many thanks
>
>   
>
> Patrick Quinn
>
> Blue Mountains, Australia
>
>
>


<Prev in Thread] Current Thread [Next in Thread>