LGM
You might want to make sure the cam does not have a slight bend in it. I ran
into that on one of my ford big blocks
after a blow up. Cam was bent about .005 but enough to cause a little
binding. Took it back to Isky and he straighten it.
Glen
----- Original Message -----
From: <LGMCAFEE@aol.com>
To: <land-speed@autox.team.net>
Sent: Friday, January 17, 2003 2:15 PM
Subject: Cam shaft bearings
> Scott I remember seeing an article in a book where they took an old cam
and
> cut some slits in the cam with a thin cut off wheel and used that to ream
out
> the bearings that were to tight. In thinking back I did that to one motor
> years ago.
> Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|