I'm convinced - A band saw it is.
Thanks,
Jim W.
-----Original Message-----
From: Richard Fox [mailto:v4gr@rcn.com]
Sent: Friday, March 21, 2003 12:34 PM
To: Albaugh, Neil; Waldron, James; land-speed@autox.team.net
Subject: Re: Re: Plasma Cutter or band saw or ?
having used a chop saw on 4130 I can say it will leave the end heat treated
and hardened. A power hawk or band saw is a much better choice. Rich Fox
----- Original Message -----
From: "Albaugh, Neil" <albaugh_neil@ti.com>
Subject: RE: Re: Plasma Cutter or band saw or ?
> Jim;
>
> A chop saw (abrasive cut-off wheel) isn't recommended for cutting 4130
steel
> tubing. The heat of friction leaves the alloy in poor condition for about
> 1/8" from the cut. I read this somewhere but I can't tell you that
source--
> I simply can't remember where I saw it.
>
> Regards, Neil Tucson, AZ
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|