land-speed
[Top] [All Lists]

RE: Dynamic fall over Vs Static dumping ( no LSR )

To: "Keith Turk" <kturk@ala.net>, <land-speed@autox.team.net>
Subject: RE: Dynamic fall over Vs Static dumping ( no LSR )
From: "James Tone" <James.Tone@AES.com>
Date: Wed, 16 Mar 2005 06:46:53 -0800
Were you wearing your neck collar at the time? Since my "bitchen"
upholstered seat was determined "illegal" by the SCTA; it now has been
mounted on a swivel stool and I use it at my desk at work.  However, the
attached roll cage keeps my arms in their proper position. J.D.



I just had to share this thought... has no merit and damn little LSR...

If your sitting in a roll around chair and feel like stretching there
are a
couple of things you oughta know first...

1.  If your sitting back in your chair and lean back and rapidly throw
your
arms over your head to the rear and you have your legs tucked under the
chair,
the center of your total mass might not exceed the point where the back
two
rollers touch the ground but the dynamic's associated with the mass of
your
body weight might carry you past the point at which you could in fact
tip
over....




________________________________________________________________________
This communication is for use by the intended recipient and contains 
information that may be privileged, confidential or copyrighted under law. If 
you are not the intended recipient, you are hereby formally notified that any 
use, copying or distribution of this e-Mail, in whole or in part, is strictly 
prohibited. Please notify the sender by return e-Mail and delete this e-Mail 
from your system. Unless explicitly and conspicuously stated in the subject 
matter of the above e-Mail, this e-Mail does not constitute a contract offer, a 
contract amendment, or an acceptance of a contract offer. This e-Mail does not 
constitute consent to the use of sender's contact information for direct 
marketing purposes or for transfers of data to third parties.

This email has been scanned for all viruses by the MessageLabs service.






<Prev in Thread] Current Thread [Next in Thread>