land-speed
[Top] [All Lists]

Re: [Land-speed] Helmet SIde Support Qs

To: drmayf@mayfco.com
Subject: Re: [Land-speed] Helmet SIde Support Qs
From: Bryan Savage <b.a.savage@wildblue.net>
Date: Fri, 22 Feb 2008 16:53:58 -0800
Mayf,
I would first call the Manufacturer of your helmet and see if they
have any ideas.

I would like a 2" wide 3/16 or 1/4 inch bar, depending on the length.
Position vertically so that it contacts the helmet at the CG of the
head - helmet assembly.
Cover that with the hard foam that is used in helmets, between
the shell and the softer padding. Cover this with 1/2 inch or more of SFI.

Tom Burkland pointed out to me that, first you must survive the crash,
then you worry about all of the other stuff. That sounded reasonable to me.

Just my opinion's,
Bryan


drmayf wrote:
> I want to try and be compliant with the new rules abot having less than 
> 2 inches side movement of the helmet. I think the rule is flawed, but I 
> don't get a vote so I want to build a better supprt. I see the nascar 
> seats have a pair of "horns" attached to that the helmet cannot rattle 
> from side to side. I want to add something like that to my roll cage. a 
> piece of flat aluminum bar stock that goes from the front bar back to 
> the rear vertical bars on each side. Then I will put some foam pad on 
> it. I think you can buy the SFI stuff in flat sheets and that may be my 
> answer for padding. Question - how wide should this bar be?  1 inch? 2" 
> Or More? How thick? 1/8 inch? 3/16"? 1/4" or more?  Thoughts or 
> comments? No I am not going to creplace my seat with one of  one of 
> thoses. Won't fit and they are way too expensive.  I am not worried 
> abotu forward head movement, just side to side. Comment on this proposed 
> solution please..
>
> mayf
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>