land-speed
[Top] [All Lists]

Re: [Land-speed] Hellooooooooooo ?

To: "Mobley-Anderson" <mactem@mebtel.net>, <land-speed@autox.team.net>
Subject: Re: [Land-speed] Hellooooooooooo ?
From: "Benn" <karhu@california.com>
Date: Sun, 2 Mar 2008 10:00:08 -0800
Sounds like you'd want a turned pilot diameter on the front of the adapter, 
indicated in to the through-bore, then a recess locating diameter on the 
rear of the adapter (also indicated in to the through-bore) for the new 
heftier tranny, right?  If you're gonna try to do it without lathe-work (or 
a CNC mill), you might use the offset bellhousing bushings that the 
aftermarket (and maybe OEMs too) offer for alignment of the rear recess 
diameter.  Then you've just gotta figure out the clutch....
Benn

----- Original Message ----- 
From: "Mobley-Anderson" <mactem@mebtel.net>
To: "'LSR'" <land-speed@autox.team.net>
Sent: Sunday, March 02, 2008 9:42 AM
Subject: [Land-speed] Hellooooooooooo ?


> I'm using a RWD Corolla bell housing (fits the engine) and mating it to
> a Supra gearbox (bigger, stronger).  The Supra input shaft is longer
> than the Corolla shaft by about 2 inches. Also the bell doesn't match
> the tranny mounting holes. I'll have to make a wide adaptor plate to
> join them and I have to make sure the shaft and crank line up exactly
> (that's what I'm scratching my head over).  I'm thinking of tying the
> adaptor plate to the frame at that point also.  This all gives me
> something to ponder on while I should be thinking about work! LOL.
> David
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>