land-speed
[Top] [All Lists]

Re: [Land-speed] Bearing clearance

To: "John Burk" <joyseydevil@comcast.net>, "LandSpeed List"
Subject: Re: [Land-speed] Bearing clearance
From: Skip Higginbotham <saltrat@pahrump.com>
Date: Tue, 11 May 2010 16:53:56 -0700
More important than clearances is oil volume. If you run a dry sump 
system, you're fine. But if you run a wet sump, be sure to have at 
least 12 quarts of oil or one of the newer blocks that have priority 
oiling. I have not so good experience...........
On the subject of clearance, with lower viscosity oil, reduce bearing 
clearances. And piston skirt clearances. Depending on how light the 
oil is, 2 to 3 thou on the rods and 3 to 4 thou on the mains. At 
least 50 psi oil pressure and even better, 10 psi for each hundred 
HP. Doug Odom is a good source of info on engine lower ends.

It matters little the brand of engine....bearings are bearings.

Good luck,
Skip







At 07:40 PM 5/10/2010, John Burk wrote:
>BBC
>
>>John, 427 what? Chevy? Ford?  If tiz chevy and a stroked small 
>>block then excuse the ring, lol.... I know nothing about them ch*vy 
>critters...
>>
>>mayf
>>John Burk wrote:
>>
>>>For a 427 stroke , 7500 rpm and the lighter oil everybody uses what sort of
>>>bearing clearance works at Bonneville .
>>>
>>>John Burk
_______________________________________________
Land-speed@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>