land-speed
[Top] [All Lists]

Re: [Land-speed] Compression Height, Ford Small Block, Of course...

To: <drmayf@mayfco.com>, <land-speed@autox.team.net>
Subject: Re: [Land-speed] Compression Height, Ford Small Block, Of course...
From: "Neil Albaugh" <neil@dbelltech.com>
Date: Thu, 17 Mar 2011 17:51:06 -0700
Mayf;

I found this:   http://www.rbracing-rsr.com/squishcalc1.html   It discusses 
deck height & "squish".

Regards, Neil  Tucson, AZ

--------------------------------------------------
From: "Larry Mayfield" <drmayf@mayfco.com>
Sent: Tuesday, March 15, 2011 9:27 PM
To: <land-speed@autox.team.net>
Subject: [Land-speed] Compression Height, Ford Small Block, Of course...

> Last week I asked about mixing and matching the cranks, pistons and rods 
> between a 289 and  302 sized motors. The use of the shorter 302 rod with a 
> 289 crank was not deemed to be a good idea because it puts the piston down 
> hole 0.065 inches. Seemingly small but apparently important in squish. 
> But when I look at a combo made for a particular engine, say the 289, 
> virtually everyone of the piston makers use something other than the zero 
> deck height  compression height of 1.6135 inches.  Most sell their pistons 
> at 1.60 inches which also puts the piston down hole by 0.0135 inches.  Is 
> that a significant amount?  I did sample  a number of products and one was 
> 1.608 which is closer.
>
> What's good?
>
> mayf
> _______________________________________________
> Land-speed@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/land-speed/neil@dbelltech.com
_______________________________________________
Land-speed@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>