| To: | mg-t@autox.team.net |
|---|---|
| Subject: | float bowl |
| From: | JVK52TD@aol.com |
| Date: | Fri, 12 May 2000 17:12:33 EDT |
I am trying to install new needle & seats in 1 1/2" carb float bowls... I had grose jets & am installing vitron tipped needle & seats... The old grose jets were installed with 1/2" space at the forked lever, why would this be ?? Book calls for 3/8" for TD carbs, since my carbs are 1/2" , 7/16" space should be used ?? Any suggestions ?? John |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Fuel Pump Back-up, Bob Howard |
|---|---|
| Next by Date: | Re: TB lights, Bob Howard |
| Previous by Thread: | TB lights, Ray McCrary |
| Next by Thread: | Re: float bowl, Jerry Felper |
| Indexes: | [Date] [Thread] [Top] [All Lists] |