| To: | mg-t@autox.team.net |
|---|---|
| Subject: | Cold Valve Clearance |
| From: | BobMGT@aol.com |
| Date: | Tue, 23 May 2000 22:19:50 EDT |
I'm finishing an engine overhaul on my TD. I know the valve clearance should be .019 hot, but what should I set it for cold before it's started? The shop manual says nothing about a cold setting. This is a bit of a catch 22. Bob Donahue (Still stuck in the '50s) EMAIL - BOBMGT@AOL.COM 52 MGTD - under DIY restoration NEMGTR #11470 71 MGB - AMGBA #96-12029, NAMGBR #7-3336 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: [mg-tabc] TC Dash Board, Bill Harkins |
|---|---|
| Next by Date: | TD Exhaust Manifold Paint, BobMGT |
| Previous by Thread: | Re: [mg-tabc] TC Dash Board, Bill707 |
| Next by Thread: | Re: Cold Valve Clearance, Lawrie Alexander |
| Indexes: | [Date] [Thread] [Top] [All Lists] |