mgs
[Top] [All Lists]

re: 3/4 switch for OD transmissions

To: <mgs@autox.team.net>
Subject: re: 3/4 switch for OD transmissions
From: <Phil=Meyers%TS=DeskCase%CS=Hou@bangate.compaq.com>
Date: Fri, 4 Aug 95 16:41:20 CDT
You could always use the backup light switch to tell when it is in reverse 
and bypass the whole deal.  ;-}

Phil
-------------
Original Text
>From John Van Valkenburgh <jvan@nando.net>, on 8/4/95 3:31 PM:
To: "MG mailing list" <mgs@autox.team.net>

>From: "A. B. Bonds" <ab@vuse.vanderbilt.edu>
>Subject: Re: speaking of OD's

[snip]
> Unfortunately, the only way I have found to get at that switch is to 
>remove the tranny (the switch is on top, under the tunnel).
[snip]
>               A. B. Bonds

Ha! Bag That.  I'd bore a hole through the top and get to it.  Call it an 
engineering improvement, yeah thats it.
As a matter of fact, you could cut away the transmission tunnel housing 
and make it a removable item.  No wait, then it would be a Triumph.  You 
wouldn't want to do that :)

Heres what ya do.  Get some small magnets and tape them to the drive 
shaft at equal spacing.  Use a magnetic pickup then to sense how fast the 
car is actually moving.  Next run a line from the tach so you can sense 
the engine speed.  Run another line from the clutch pedal to make sure 
the clutch is engauged.  Using these three you can calculate if the car 
is in 3rd or 4th.

Now, if the car is coasting downhill in neutral you could not tell, but 
its neutral anyway so it does not matter.

The only other consideration is reverse.  Heck, just don't use reverse.  

Now isn't that easier than removing the tranny ? :)

Best of luck,
John Van Valkenburgh

<Prev in Thread] Current Thread [Next in Thread>