mgs
[Top] [All Lists]

Re: Aligning Drive Shaft

To: David Earl Brown <debrown@concentric.net>
Subject: Re: Aligning Drive Shaft
From: Dave Houser <mgs4dave@warwick.net>
Date: Wed, 18 Feb 1998 10:46:44 +0000
One other note on this drive shaft thread....
There is a pair of alignment arrows at the trans end of every MG shaft
I've taken off!
If you look very carefully(through the rust), you'll see what looks like
a thin line on the thinner sliding shaft attached to the back of the
trans joint. At the forward end of the driveshaft there is another thin
arrow line(ya gotta look carefully). These should align so the yokes
front and rear are the same. That's what's important.

Hope this is clear,
Cheers,
Dave Houser

<Prev in Thread] Current Thread [Next in Thread>