To add to the valve cover replies -
I use the standard cork gasket. I make sure the surfaces are clean and
smooth on the head, and clean on the valve cover. Then I put a very thin
layer of gasket sealer on the top and bottom surfaces of the gasket - I use
the pliable silicone gasket sealer.
The gasket should fit on the cover, between the clips (or whatever they are
called). Squeeze it in. It should fit snug so that the gasket does not fall
out when you install the cover.
As mentioned, tighten with minimal torque - 4-8 lbs.
I usually like to let the car sit overnight to insure the gasket sealer
sets up. The silicone gasket sealer is like rubber when it sets up.
I can remove the cover and reuse the gasket several times, just wiping the
surface clean. I usually adjust my valves twice a year (or 6000 miles if
the car gets a lot of miles) and I replace the gasket about once a year.
David
71 BGT
>
>Went to change my oil today, and when finished, kablooey, new oil all over
>the place.
>I found the culprit at the valve cover. About 3 inches of gasket on the left
>side had squirmed inside the cover, allowing oil to spew out. Why it waited
>'til then, I have no idea, other than I overfilled a tad and Punkin is just
>being considerate by not losing it at 60mph on the highway.
>Question #1: I used #2 gasket sealant when I installed, does everyone use
>this stuff? Is it better to let it "set" for a while and "glue" the gasket
>to the cover before installing? Is that where I went wrong?
>Question #2: Does anyone know of a more common car that will cross over
>nicely for use on a B head? The reason the gasket warped to the inside is
>that it seemed to be a fraction too large. It was ordered from Moss. In my
>neck of the woods, no shop carries gaskets for a '73 B. But it seems to be a
>pretty average size. I suppose I could make my own.
>My red charge light coincidentally started glaring at me at the same time,
>but since the alt and belt are on the opposite side, I probably am just due
>a belt tightening.
>When it rains it poors! But I love it! (I'm sick...hehe) "Punkin" is doing
>well otherwise, giving good daily service.
>Still gotta figure out that horn problem too...but it's freakin' HOT out
>there!
>
>Dan
>73 B
>
>
>
|