[Top] [All Lists]

Re: New Water Pump--Correction

Subject: Re: New Water Pump--Correction
From: Bullwinkle <>
Date: Fri, 08 Jun 2001 22:02:06 -0600

Funny thing is, the old pump is not leaking during the flushing
Just the same, I'm going to replace it anyway.

Typical.  There's no presure on it as the cap is off.  That's a
trick on the road if you start to have a leaking hose, pump,
etc.  After the engine has cooled down, unscrew the cap to the
safety notch.  This releases the pressure in the system and leak
stops or reduces significantly.

1)  Run the engine with no coolant for a 10-15 seconds to seat
the seal before adding coolant.  If the engine is cold to start
with, no damage will be done.

2)  Unless you need freeze protection below zero degrees F, then
use 30% antifreeze.  A 30% solution will cool better.  Even below
zero the coolant will not freeze solid.  It turns to mush though,
and the water pump can't move it.  That's not a problem if the
car is NOT driven in the winter.


/// mailing list
///  (If they are dupes, this trailer may also catch them.)

<Prev in Thread] Current Thread [Next in Thread>
  • Re: New Water Pump--Correction, Bullwinkle <=