mgs
[Top] [All Lists]

Re: Ujoint off Steering Column

To: "Bob Howard" <mgbob@juno.com>
Subject: Re: Ujoint off Steering Column
From: "Telewest \(PH\)" <paul.hunt1@blueyonder.co.uk>
Date: Thu, 26 Sep 2002 18:19:35 +0100
A sticky stuff a bit like chewing gum used to stick kids pictures to the
kitchen wall, but doesn't go hard.

----- Original Message -----
From: "Bob Howard" <mgbob@juno.com>
To: <paul.hunt1@blueyonder.co.uk>
Cc: <mgs@autox.team.net>
Sent: Thursday, September 26, 2002 3:39 PM
Subject: Re: Ujoint off Steering Column


>   Thanks, Paul.   What is BluTack?
>    This may be an issue only with the collapsible column; I don't know as
> I've never seen a later non-collapsible column in the USA.
> Bob
>
>
> On Thu, 26 Sep 2002 13:07:33 +0100 "Telewest \(PH\)"
> <paul.hunt1@blueyonder.co.uk> writes:
> > Only by replicating them.  Some have mentioned using BluTack, I have
> > wrapped stiff wire round the shaft with one free end where the point
> would
> > be, which can be set by rotating each shaft and adjusting the wire
> until
> > rotates at a single point in space and doesn't describe a circle.
> Remember the
> > proper points also set the londitudinal position of each shaft, not
> just
> > their relative lateral position.  On my non-collapsible column the
> inner
> > moves in and out freely, its final position being set by the UJ, so
> that is
> > not an issue.  It may be with collapsible columns.

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>