What was on the car was right. I found the same thing when I did the job -
the new cylinder had the bleeder in the wrong hole. Just move the bleeder
to the other hole!
Richard & Sammy ('73 Black Tulip BGT)
2009/1/14 Matthew Milkevitch <mmilkevitch@yahoo.com>
> Fellow Listers;
>
> While recently installing a new clutch slave cylinder on my '74 MGB-GT I
> noticed something. The new clutch slave (purchased from Moss...its a
> Lockheed unit) had the hose and bleeder positions reversed. On the old
> (leaky) unit, the hose attached to the connection that faces the front of
> the car, and the bleeder faced the right side of the car (passenger's).
>
> On the new unit, it's reversed.
>
> So I'm confused...could anyone confirm where the hose is supposed to be
> attached (front fitting or right side fitting)?
>
> Thanks for all the assistance...hope everyone is keeping warm (its below
> zero here with wind chills).
>
> Matt Milkevitch
> '74 B-GT
> Willow Grove, PA
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as rbgosling@googlemail.com
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|