Malcolm, the rubber mount attaches to the transmission with 2 bolts each, and
has a central screw that attaches the
mount to the cross member. See here -
http://i24.photobucket.com/albums/c30/ddibiase/1976%20MGB%20Engine%20Work/P7060032.jpg
So, the rubber mount stays attached to the trans when you pull the crossmember
away.
Dan D
Central NJ USA
'76 MGB Tourer
'65 MGB Tourer (Project)
NAMGBR #5-2328
http://dans65b.blogspot.com/
http://dans76b.blogspot.com/
http://dansautoblog.blogspot.com/
http://dans-life-blog.blogspot.com/
twitter: dandibiase
________________________________
From: Malcolm Jeffcock <msjeffcock@eastlink.ca>
To: mgs@autox.team.net; members2@batans.ca
Sent: Sun, June 13, 2010 6:23:34 AM
Subject: Re: [Mgs] [Members2] mg engine
Thanks to everyone who replied. I have had a ;ook and can see the bolts
"inside". Question though, are the rubbers that the bolts appear to pass
through attached to the cross memberin any way? I see from the photos that Dave
was kind enough to send me that they are least removeable from the cross member
but I am wondering if when these bolts come out will the cross member and
rubbers just drop or will the rubber remain attached to the gear box?
Malcol
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/mgs/d_dibiase@yahoo.com
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|
