I have progressed past this point. I was packaging up the slide hammer to
return to HF but decided to give it a try again with the two arm puller using
the 2 remaining arms. Several whacks and it popped out.
I have pulled out the gears and washers. Problem is that there is a copper
washer behind the differential gears, very close to the same size as the new
fiber thrust washers. I see no reference or mention of this piece unless it
is the same, just different material. Should I be using both or just the fiber
one, moss part 267-140?
David Councill
67 BGT
-----Original Message-----
From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net] On Behalf
Of Stephen West-Fisher
Sent: Sunday, April 17, 2011 2:51 PM
To: mgs@Autox.Team.Net
Subject: Re: [Mgs] Tale of the rear axle
The rear bearing is a press fit.
I can't visualize it now (it's been a long time) but you can space out the
drive flange with something and use an impact wrench on the axle nut to pull
the axle and bearing.
--
Stephen West-Fisher
N4IK
-----Original Message-----
From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net] On Behalf
Of Councill, David
Sent: Sunday, April 17, 2011 2:55 PM
To: mgs@Autox.Team.Net
Subject: [Mgs] Tale of the rear axle
I am partway into a rear axle thrust washer replacement. I am now at the stage
of trying to pull out one of the half shafts.
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/mgs/dcouncill@msubillings.edu
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|