mjb.,
It is tough to tke a picture in that area with an assembled car. I
can tell you that the original bolt for the forward P-clip goes
through the horizontal air pan in the outboard corner near the body
mount. You need to form the hose to fit first, push it onto the top
connector pipe, then position the P-clip and install the bolt
last. It is a lot easier if the grille is not in place at the
time. That bolt has given me so much grief over the years that I
drilled another hole inboard from the hose and turned the P-clip
around to make life easier.
Barney Gayord
1958 MGA with an attitude
http://MGAguru.com
At 05:37 PM 4/6/2012 -0600, Mark J Bradakis wrote:
>I was working on an MGA today replacing the 4" air duct hoses. The
>one that goes to the heater was no problem. The one on the left
>side of the engine bay that goes ? and needs a bracket attached at ?
>was a problem.
>
>Anyone have some photos detailing the location and mounting of this hose?
>....
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|