Why not use an epoxy coating on the floorboards?
Simon
On Thu, Nov 14, 2013 at 12:49 PM, Richard Lindsay <richardolindsay@gmail.com
> wrote:
> Hi Friends,
>
> Today I shifted gears, so to speak. I'm sending my TD's distributor
> off for repairs and recalibration. Engine tuning is on hold.
>
> Today, I retrieved the new floorboards from storage (boot of my
> honkin-big Silver Shadow) and put a coat of urethane on them. The
> boards, from Moss, are made from pretty pine plywood. I don't know
> anything about the product, other than its appearance, so I have to
> assume that it needs waterproofing. Here's how the boards look as I
> began painting.
>
> http://www.aubard.us/MGTD/20131114_132118.jpg
>
> Its about 50 degrees F here today so paint dries slowly - even
> fast-dry urethane! Still, it was fast enough to finish the job, on
> both sides.
>
> http://www.aubard.us/MGTD/20131114_140830.jpg
>
> The edges have also been sealed.
>
> http://www.aubard.us/MGTD/20131114_140841.jpg
>
> I'm going to stop at one coat because I don't really expect this car
> to see rain. The metal insert at the driver's feet, is still grimy.
> Its one of those parts that I didn't clean upon removal, so I have to
> do so now. Tomorrow I will trial-fit the floorboards. The passenger
> side is ready to go in. The driver side 'may' be ready too, but I
> still need to bleed the brakes. I don't know if that's easier with the
> driver-side floorboard out.
>
> -rick
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/simon.d.matthews@gmail.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|
