Dave,
If you're using a rib case trans, you should go the cast plate and the
correct 1098 clutch.
Gerard
At 5:23 PM -0700 8/18/02, David Kernberger wrote:
>8/18/02
>
>Hello all.
>
> Will the thin rear engine/trans. plate from a 948 cc Morris engine
>fit onto the rear of an 1100 cc Sprite engine (The one with the large
>2-inch main bearings/10CC engine code)?
>
> If so, is there a small size (like 948 stock) clutch which will
>mount onto the 1100 flywheel, fit inside of a smoothcase bell housing, and
>be able to carry the torque of a slightly-modified 1100 engine?
>
>Regards,
>Dave Kernberger
Search for Low Airfares, Great Hotel Deals,
Car Rental Discounts and Vacations and Cruises
http://partner.onetravel.com/go/go.cfm?GoID=32421
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morris
|