oletrucks
[Top] [All Lists]

RE: [oletrucks] Engine questions

To: oletrucks@autox.team.net
Subject: RE: [oletrucks] Engine questions
From: MIKE RAHL <MRAHL@martinmartin.com>
Date: Wed, 18 Aug 1999 10:46:57 -0600
The 55 235 I just recently dissassembled had shims under the main bearing
caps.  According to the shop manual they were used for bearing adjustment.
My crank was ground 10/10 and I don't plan on using any shims on reassembly.
The 56 shop manual supplement states that the bearing shims were eliminated
for that year.

-----Original Message-----
From: Allen L. Jones [mailto:ALJ@hartcrowser.com]
Sent: Wednesday, August 18, 1999 9:04 AM
To: oletrucks@autox.team.net
Subject: Re: [oletrucks] Engine questions


However, there are shims installed at the factory under the main bearing
caps in a lot of 235s and 261s.  Ever notice those really, really thin
sheets of metal under the mains?  Typically under the rear bearing cap?
It's critical to keep track of these guys during disassembly and put them
back in the exact same spot.  If you lost or forgot where they go, wouldn't
line boring the block take care of things?  If you talk to some Inliners,
they always line bore their block anyway.  I suggest you talk to a machinist
that is more familiar with your situation.  Good luck!

Allen in Seattle
'50 3100
Inliner  #2235

>>> "jack halton" <safesix@worldnet.att.net> 08/18/99 04:32AM >>>
Either this guy is confused, or you have an older motor. The older babbitt
rod motors used shims on the rod bearing caps, but later 235s use insert
bearings - no shims required.

Most "production" machine shops don't want to work on older engines, as it
takes more time away from their more profitable operations. It's usually
better to contract with them for just the major machining operations and do
the assembly yourself. Or else find a shop that specializes in older stuff -
but be prepared to pay more.

Jack / Winter Park FL

----- Original Message -----
From: Antonio R. Tijerino <antonio@innercite.com>
To: Ole Trucks <oletrucks@autox.team.net>
Sent: Wednesday, August 18, 1999 1:26 AM
Subject: [oletrucks] Engine questions


> I have a question for the engine rebuilding experts. I am getting a '56
> 235 cid engine that has been recently bored 0.30 and the crank has been
> ground 0.10/0.10. New cam bearings installed. I have read the 6 part
> engine rebuilding article posted on the oletrucks list and does not
> mention anything about the main crank bearings "shims". I took the block
> to the machine shop and the machine shop guy told me that installing the
> "shims" was a job on itself and that it make the price of putting the
> engine together more expensive. Can anyone tell me more about these
> shims, how to install them and what is the story? is this guy trying to
> pull my leg? can I install the shims myself?
>
> Thanks,
>
> Antonio,
> '53 3100
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>