oletrucks
[Top] [All Lists]

Re: [oletrucks] Break cylinder question

To: "Terry S. Glines" <ace0027@attglobal.net>
Subject: Re: [oletrucks] Break cylinder question
From: ADvent@thuntek.net
Date: Sat, 19 Feb 2000 14:25:59 -0700
you also can wrap solder around the the pipe as you would if you were winding a
coil. still, the tool is the best way as somebody has mentioned before. the 
tool is
only about 10 bucks for a wanna be snap on brand.
new mexico jim
51 two ton
50 ½ ton

"Terry S. Glines" wrote:

>     Started not to mention this, but why not? =)
>     There is one method of bending tubes that I have used sevral times. Cut 
>the
> tube to length, then fill it good and tight with sand. Now you still want to 
>go
> slow and easy on tight corners, but it will keep the line from reaching that
> dreaded "Crap! to far" point.
>
> Terry & Ace
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>