I had a chock cable that worked and needed to add a repro throttle cable. I
have completed this - what fun it is under the dash. I have it hooked up
just like the old frozen one was. I can work the throttle from the button.
However it is not working in the same way as the chock. The chock will stay
out to exactly where I place it. The throttle will slide back in and only
let me keep the motor throttled up a little. Also I would like to make it
so that the T is upright. I can get it to spin about 30 degrees off on
either side of up but I can not get it to stay upright. I have attempted to
re-connect the cable end to move the T with no change. Any ideas on what
needs to be done to tweak this?
46 Chevy 3104
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959