I think some 16 ga. would work nicely! The 18 ga. is a little harder to
come by and warps a lot easier that why I say 16 ga. Also be sure to ask
for reminents "let over cutting from a full sheet" which will be less
expensive.
Joe
----- Original Message -----
From: <JetandKen@aol.com>
To: <oletrucks@autox.team.net>
Sent: Thursday, December 26, 2002 8:52 PM
Subject: [oletrucks] sheet metal
> I'm going to buy some sheet metal to finish my firewall, but I'm not sure
> what to buy I don't what to go to thick and be hard to work with, or to
thin
> either. I plan on welding it in, so it is smooth on the engine side. Any
> suggestions? Thanks Ken
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|