[oletrucks] Distributor Gear

["Doug Wathor" <Wathor@attbi.com>]

I'm now at the distributor... I took off the lower distributor gear from my
original 235 distributor, in order to fully disassemble and clean all the
parts and shaft. The gear was held on by a 3/16 pin, peened over on both
sides. Does anyone see any potential problem with re-installing this gear to
the distributor shaft with a standard split roll pin? Thanks.

Doug
1956 1/2 ton (Being restored)
1963 SW Corvette (Restored)
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959