oletrucks
[Top] [All Lists]

[oletrucks] rochester carb choke screws, etc.

To: napco4x4@yahoogroups.com, oletrucks@autox.team.net
Subject: [oletrucks] rochester carb choke screws, etc.
From: mark@noakes.com
Date: Sat, 01 Nov 2003 20:25:41 -0800 (PST)
A couple of weeks ago, I was looking for choke plate screws to rebuild my 
Rochester
2-bbl carb.

They are brass 6-32 about 1/4" long with a special small head on them.

Checked hardware stores; head way too large.

Checked Corvette vendors at Knoxville Expo; they all buy used carbs in lots of 
100 or so
and strip them out for parts(so that's why there aren't many of the old base 
model carbs
out there).

Checked various rebuilder and performance shops; they can't get them.

Checked a local bolt and screw specialty store; they can't get them either.

Hey, this was getting old...

Then I ran across a carb rebuilder that does Corvair carbs and early vette carbs
(Corvette side draft and Corvair turbo are both Carter YH); he said that they 
are a
special shaft screw and he can get them for 20 cents a piece...so I bought a 
handful.

The contact is Grant Wolfe, Wolfe Enterprises, and his email addr is:  

gyoungwolf@aol.com

He does rebuilds on just about anything including the GMC Zenith carbs.

Mark Noakes
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>