Jeff,
I don't think you could acurately torque them with a big torque wrench.
They make smaller ones designed for low-torque use.
I think you will be fine using your "built-in torque wrench"...
Ulix
On Sun, 11 Jan 1998, Jeff Boatright wrote:
> I just got my speed bleeders in the mail. The instructions specify torquing
> them at a value in inch-pounds. My torque wrench is calibrated in
> foot-pounds. Is the conversion simply a matter of dividing by 12?
>
> TIA,
>
> Jeff
>
> ______________________________________________
> Jeff Boatright __o_\__ '65 A-H Sprite
> http://userwww.service.emory.edu/~jboatri/sprite/sprite.html
>
>
Ulix __/__,__
.......................................................... (_o____o_)....
'67 Sprite
|