spridgets
[Top] [All Lists]

Re: oil dipstick tube question

To: "William West" <will_thane@email.msn.com>, "Triumph List" <triumphs@Autox.Team.Net>, "Spridgets" <spridgets@Autox.Team.Net>, "MG LIST" <mgccnwc-list@eskimo.com>
Subject: Re: oil dipstick tube question
From: Larry Macy <macy@bblmail.psycha.upenn.edu>
Date: Sun, 8 Feb 98 09:07:25 -0500
Reply-to: Larry Macy <macy@bblmail.psycha.upenn.edu>
Sender: owner-spridgets@Autox.Team.Net
On 2/7/98 8:07 PM so and so  William West said. (And I quote)

>
>Greetings All!
>
>How is the oil dipstick tube removed/installed on a spitfidget 1500?
>
>Let's just say there was a little 'roll-over' accident with my block, and my
>tube got bent.  I bent it back and it seems to be ok, but now I'm curious as
>to how it might be removed and replaced.
>
>Thanks again!
>
>Will
>
>
As I recall it seems like a press fit. If you bent it it shouldn't matter 
too much as we are dealing wih "quarts" not ml.

good luck

Larry Macy
78 Midget

<Prev in Thread] Current Thread [Next in Thread>