| To: | spridgets@Autox.Team.Net |
|---|---|
| Subject: | Re: tach |
| From: | John Colosimo <jcolosim@tbcdsb.on.ca> |
| Date: | Thu, 7 May 1998 10:15:16 -0400 |
| In-reply-to: | <3550E5E3.FB0ABAF1@bellsouth.net> |
| References: | <l03102801b1762d8fc4fa@[205.207.71.26]> |
| Reply-to: | John Colosimo <jcolosim@tbcdsb.on.ca> |
| Sender: | owner-spridgets@Autox.Team.Net |
Hi mark, The part I am trying to identify is in the lower left corner when you look at it from the face side. Just above the black 75 ohm 5% resistor. It appeared to have been a flat bit of ceramic with a wire soldered to each side of it. The ceramic has crumbled up. John Colosimo >If it was the capacitor that exploded it was 2.2 MFD. Anything close >will work but you will need to calibrate if after the fix. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| Previous by Date: | Exhaust line install questions, Philip Hubbard |
|---|---|
| Next by Date: | Re: 74 midget, Larry Macy |
| Previous by Thread: | Re: tach, Mark Endicott |
| Next by Thread: | Re: tach, John Colosimo |
| Indexes: | [Date] [Thread] [Top] [All Lists] |