spridgets
[Top] [All Lists]

Re: Protecting Flexible Brake Lines

To: "Richard D. Arnold" <richard.arnold@juno.com>
Subject: Re: Protecting Flexible Brake Lines
From: hello39@idt.net
Date: Fri, 05 Jun 1998 11:14:56 -0400
Cc: spridgets@Autox.Team.Net, mgs@Autox.Team.Net
References: <19980605.094439.5175.3.richard.arnold@juno.com>
Reply-to: hello39@idt.net
Sender: owner-spridgets@Autox.Team.Net
Rich,
Have used a small gauge spring and slid the brakeline into it. The spring
protects the exterior of the hose and remains flexable also. Occassionally, I
seen chaffing from oversized tires and twisted lines and the spring avoids
that as well.
They should be available at any hardware or automotive store. make sure the
spring is easily flexed and not too stiff or made of large gauge steel wire.
Alan

Richard D. Arnold wrote:

> All:
>
> I'll be installing new flexible brake lines on Miss Molly this weekend.
> The outside coverings of the old ones are in horrible shape:  cracked,
> weather checked, dinged up from road debris, etc.  I have thought about
> wiping the hoses down with a rubber protectant then sliding a length of
> heat shrink tubing over them to provide a measure of protection.
>
> Will this cause more problems than it prevents, or should I just keep the
> hoses clean and wiped them occasionally with a protectant?
>
> Rich




<Prev in Thread] Current Thread [Next in Thread>