| To: | "Evangelos G. Makris" <emakris@hol.gr> |
|---|---|
| Subject: | Re: rear hub pulling question |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Fri, 04 Jun 1999 17:30:41 -0400 |
| Cc: | spridgets@autox.team.net |
| Organization: | Positive Earth Drivers Club |
| References: | <375730E7.12C3@hol.gr> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@autox.team.net |
"Evangelos G. Makris" wrote: > > I am trying to remove the rear hubs on a Sprite with solid wheels. > > Could you please tell me what the central bolt of the "generic > hub puller" should lever against? Is this a "special" tool or > is there some practical and easy way around it? > > After all, there is only fresh air at the centre of the hub... > > Thank you > Evangelos Evangelos Like Ulix said, a big washer works for me. -- Frank Clarici Toms River, NJ Bugeye Sprite 67 Sprite 59 A40 http://www.exit109.com/~spritenut/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | re: Who the h* is Montana Bob?, CONAN |
|---|---|
| Next by Date: | Re: Largest Brewery? [WasChurch key (NO LBC)], toyman |
| Previous by Thread: | Re: rear hub pulling question, Shawn Knight |
| Next by Thread: | Re: rear hub pulling question, Angela Hervey-Tennyson & Peter Westcott |
| Indexes: | [Date] [Thread] [Top] [All Lists] |