Re: Structural Repair

David,
Is there anything specific that one can buy to use as a heat sink, or is
this left up to one's imagination? (like putting a piece of metal in the
freezer, then holding it behind the work area or something)
Thanks,
Bob
-----Original Message-----
From WRROOPE at aol.com <WRROOPE@aol.com>
To: DLancer7676@cs.com <DLancer7676@cs.com>; boxweed@thebest.net
<boxweed@thebest.net>; atocci@advanta.com <atocci@advanta.com>
Cc: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Wednesday, March 15, 2000 9:23 PM
Subject: Re: Structural Repair


>David is right as far as the welding sequence, but i would also add that
you
>use a readily available heat sink to minimize any warping. just my 2 cents
>worth
>bill r
>74 midget