Was:Dist Problem Now:IT'S ALIVE!

To:	midgetsprite@yahoogroups.com
Subject:	Was:Dist Problem Now:IT'S ALIVE!
Date:	Wed, 12 Jun 2002 20:15:11 -0500
Cc:	"Race, Group" <I-Race@yahoogroups.com>, Spridgets <spridgets@autox.team.net>, "YahooGroups, SpriteMidget" <lbcandnonlbc@yahoogroups.com>
References:	<3D07E627.57706DC9@digitex.net> FILETIME=[981C0810:01C21276]

I used a set of "BF" tm. channel lock pliers to twist and remove the sleeve
that the dizzy bolts to. I then turned the shaft two sets of teeth, and it
now will run!!! The vacuum advance brass line is bumping the back of the
genny, but IT RUNS!!! I will turn it back one tooth tomorrow, it is getting
dark and the mosquitoes are getting bold, BUT IT RUNS!!!!

Brad

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread]	Current Thread	[Next in Thread>
Was:Dist Problem Now:IT'S ALIVE!, Unknown <= Re: Was:Dist Problem Now:IT'S ALIVE!, Unknown

Previous by Date:	Re: Dist Problem, Unknown
Next by Date:	Re: Whats next??, Unknown
Previous by Thread:	Re: Dist Problem, Unknown
Next by Thread:	Re: Was:Dist Problem Now:IT'S ALIVE!, Unknown
Indexes:	[Date] [Thread] [Top] [All Lists]