In a message dated 6/28/02 5:52:26 PM Eastern Daylight Time,
cbking@alum.rpi.edu writes:
> The engine bolts are 5/16, and the holes in the stand arms are much larger -
> will this present a problem?
>
It shouldn't. I haven't put my 1500 blocks on engine stands, but I have my
1275. I think if you use washers under the bolt heads and draw them up tight
you should have no problems. I don't remember how much larger the holes are
than the bolts. My 1275 has been on the stand for a few years now.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|